DCS F/A-18C CASE I carrier landing

Written by Phil on . Posted in DCS F/A-18C, Latest

Ever since this module was released in early access, I have been putting many hours into learning, training and practising carrier landings. This module is a complete game changer. Real F/A18C Hornet pilots have been flying the simulation and discussing the flight model, real life procedures and how to do Case 1 recoveries. They fly it and you can see the skill level. Fantastic!

It’s all about hitting benchmarks during the approach.

1- Enter 10nm diameter orbit over the boat at 2,000 ft at 250kts using BARO hold and ATC

2- Set TCN to the boat and set boat TCN course line to heading

3- Set up the jet: hook down, displays, heat, radalt to HUD, anti-skid off, hook bypass carrier, and radalt gauge to 370 ft

4- Break the 2,000 ft deck when abeam and behind the boat and approach the boat from the starboard side. Pass the boat at 350 kts

/ 800 ft

5- When at most 1.5 nm ahead of the boat (closer if you are more seasoned), break into the pattern

6- Gear down and flaps to full when below 250kts

7- Level off on the downwind at 1.2 to 1.3nm abeam the boat’s course line

8- Establish 8.1 on-speed AoA at 600ft. Power and trim.

9- Once the boat’s round down on the stern is visible, roll into the groove with 30 degrees of bank in gradual decent (100-200 ft/min) for the first 90 degrees of turn.

10- Roll out on groove and adjust height with power to keep IFLOS ball centered. Combat recovery 8 seconds in the groove or 12-16 seconds for standard groove time.

I can get an “OK Pass” (which is a grade the Landing Signal Officer gives for every approach) about one in twenty. The challenge is huge but if you put the hours in the rewards start to come.

If you are interested in Naval Operations and in particular carrier ops. This really is worth getting even in it’s current early access state.

Trackback from your site.

Leave a comment